4. Set Up and Calibration Procedures - Set Up Tips
Set Up Tips
Table 5 contains tips that will help you view, verify and enter the operating parameters more quickly. If
you can not change the parameters, check the status of the " SET LOCK" parameter. Also some
parameters require that you enter a security password before you access or change the parameter value.
Function
Displaying Groups
Displaying Functions
Scrolling
Changing values quickly
Exiting Set Up mode
Timing out from
Set Up mode
Set Up Groups
Pressing the SET UP key on the keypad provides access to the various set up groups and allows you to set
up operating parameters, (such as input types and alarms), calibrate the actuator's inputs and outputs, set
communications, and check actuator status. Table 6 on the next page lists the set up groups that are
available by using the SET UP and FUNCTION keys on the keypad.
30
10260S HercuLine® Actuator Installation, Operation and Maintenance Manual
Table 5 Set Up Tips
Use the SET UP key to display and scroll through the set up groups. The
group titles are listed in the order they appear on the actuator display.
Use the FUNCTION key to display the individual function parameters
under each set up group. The prompts are listed in the order of their
appearance in each group. See Tables 8 through 19.
Pressing and holding the SET UP key will scroll through the set up
groups. However, when any set up group is displayed, you can scroll
through the set up groups twice as fast using the
any set up group, hold the FUNCTION key in to scroll through the
function prompts within that group.
When changing the value of a parameter, you can adjust a more
significant digit in the upper display by holding in one key
and pressing the other
•
The adjustment will move one digit to the left.
•
Press the key again and you will move one more digit to the left.
To exit Set Up mode, press the DISPLAY key.
This returns the display to the same state it was in immediately preceding
entry into the Set Up mode.
If you are in Set Up (configuration) mode and do not press any keys for
thirty seconds, the actuator display will time out and revert to the mode
and display that was being used prior to entry into Set Up mode.
Tip
or
or
key at the same time.
key. When in
or
key,
Revision 5
7/07