Digital Input Set Up Group; Display Set Up Group; Table 15 Digital Input Set Up Group Parameters; Table 16 Display Set Up Group Parameters - Honeywell HercuLine 10260S Installation, Operation And Maintenance Manual

4. Set Up and Calibration Procedures - Digital Input Set Up Group

Digital Input Set Up Group

Table 15 lists the parameters and selections availible for the SET DIGINP group.
Lower Display
Prompt
DIGINP
EndPos *

Display Set Up Group

Table 16 lists the parameters and selections availible for the SET DISPLA group.
Lower Display
Prompt
DECMAL
EUNITS
46 10260S HercuLine® Actuator Installation, Operation and Maintenance Manual

Table 15 Digital Input Set Up Group Parameters

Upper Display
Selections or
Range of Setting
Digital Input State—Selects the position of the actuator in
response to a digital input signal (contact closure).
NONE None—No action by the actuator.
UP Up—Actuator motor moves to full scale value.
DOWN Down—Actuator motor moves to zero value.
USER User selected value—Actuator motor moves to a customer-
selected value.
* Allows setting of End Position Value.
0 – 100. END POSITION VALUE—(DIGINP USER only) Selects the
(in percent) motor position you want the actuator to go to when digital
input signal present (contact closure).

Table 16 Display Set Up Group Parameters

Upper Display
Selections or
Range of Setting
DECIMAL POINT LOCATION—This selection determines
where the decimal point appears in the display.
8888 None
[default]
or
888.8 One Place
Note: Be sure the selection agrees with the value to be
displayed. If display value requires 4 whole digits, the
decimal will not show.
UNITS DISPLAY—Selects the units of the position display.
PCNT Percent—Shows actuator position as a percentage of span.
(0 to 100%)
DEG Degrees—Shows the actuator position in degrees of
rotation. (0 to 90°). Note: Not accessible when characterizer
= CUST.
Parameter Definition
Parameter Definition
Continued on next page
⇒
Revision 5
7/07