Troubleshooting - AEG RWE72101DB User Manual

Table of Contents

Advertisement

Available languages

Available languages

TROUBLESHOOTING

WARNING!
Before troubleshooting, discon-
nect the power supply. Only a
qualified electrician of competent
person must do the troubleshoot-
ing that is not in this manual.
Problem
The wine is too
warm.
Interior lighting
does not work.
Unusual noises.
Heavy build up of
the frost, possibly
also on the door
seal.
The compressor
does not start
immediately
after changing
the temperature
setting.
Water on the
floor.
RWE72101DB_Wine_cellar_AEG_EN_EL.indd 13
Possible cause
Temperature is not
properly adjusted.
Door was open for an
extended period.
The appliance is near a
heat source.
Light bulb is defective.
Appliance is not level.
The appliance is touching
the wall or other objects.
A component, e.g. a pipe,
on rear of the appliance is
touching another part of
the appliance or the wall.
Door seal is not air tight
(possibly after changing
over the hinges).
This is normal, no error
has occurred.
Water drain hole is
blocked.
ENGLISH
IMPORTANT!
There are some sounds during
normal use (compressor, refriger-
ant circulation).
Solution
Please look in the "Use"
section.
Open the door only as long as
necessary.
Please look in the "Installation"
section.
Please look in the
"Maintenance" section.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend
the component out of the way.
Carefully warm the leaking
sections of the door seal with
a hair dryer (not hotter than
approx. 50 °C). At the same
time shape the warmed door
seal by hand such that it sits
correctly.
The compressor starts after a
period of time.
See the "Cleaning" section.
13
02/11/16 8:48 PM

Advertisement

Table of Contents
loading

Table of Contents