Honeywell CNI4 Operating And Installation Manual page 31

7 Configuration
Select the check-box next to an Item number, enter a value in the text box provided and then
click on Write Item button to write the value against the item in the connected
instrument/device. You can search for a specific item number and can also modify multiple
Item Numbers at once. You can also use the Read Item button (enabled only when an item is
selected) to read the currently configured value of the item numbers.
Set the following parameters:
Item No. Description
333 Call-in Trigger
449 Switch Filtering
486 Modem AT-Command Enable
334 Scheduled Call-In Date
335 Scheduled Call-In Time
336 Call-In Retry By
339 Scheduled Call-In Phone number
485 Call-Out Stop Time
490 Call-Out Start Time
493 Alarm Call-In Phone number
495 Modem Retry Interval A
496 Modem Retry Interval B
497 Modem Retry A Count
12. Click Disconnect to disconnect MasterLink from the Pulse Accumulator. On successful
disconnection from the Pulse Accumulator, a status message is displayed. Close the pop-up to
acknowledge the message.
Recommended Value
3 = Alarm & Scheduled Call-in
1 = Filter Both Channels
1-Yes
Set to the desired Call-In Date
Set to the desired Call-In Time
Instrument
<IP>/<Port>Example:
192.168.1.1/50467
00:00:00
00:00:00
<IP>/<Port> Example:
192.168.1.1/50467
5 minutes
1440 minutes
3
Honeywell
| 27