Creating A Video Conference (Multisite) - Cisco TelePresence Series User Manual

Version tc6.0
Hide thumbs Also See for TelePresence Series:
Table of Contents

Advertisement

Cisco TelePresence System Profile Series, Codec C Series, Quick Set C20, SX20 Quick Set, MX200, MX300
Table of Contents
Creating a video conference
(MultiSite)
If your video system is equipped with the optional
MultiSite feature you may call more than one to initiate
a video conference.
The MultiSite feature allows you to call three other
systems on video plus a fourth system on audio only
(for example a mobile phone).
This means that the conference can consist of up to
four video participants (yourself included) and one
audio participant.
If you want to initiate a video conference, you must
call each participant one by one.
Call settings. Those you call may have video systems
with different capabilities. One or more of them may,
for example, be on an ADSL system with limited
bandwidth (compared to the others). You may then
set the Call settings to a (normally lower) call rate
suiting his or her system before you call that person.
However, that call rate will affect that specific part of
the video conference only. Other participants will not
experience a lower call rate because of this.
See also the article
Video conferencing—calling more
on page 15
than one (optional)
D14582.09 User guide Profile Series, Codec C Series, Quick Set C20, SX20 Quick Set, MX200, MX300
All contents are copyright © 2010–2013 Cisco Systems, Inc. All rights reserved. Version TC6.0, 01.2013
Getting started
Video meetings
.
Scheduled meetings
Place a call to the first
participant.
Call the next
participant in the usual
way.
Repeat the procedure from
, if
needed.
A maximum four video systems
(yourself included) and one audio call
may participate.
If you initiated the conference you will be able to terminate the entire conference as well.
The other participants, however, may only disconnect themselves from the conference.
16
Managing Contacts
The Settings
Once you are
in the call, tap Add.
Tap Add to place the second
call, initiating a conference. You
may adjust Call Settings before
you place the call, if needed.
Tap END to terminate the
conference.
User guide
www.cisco.com

Advertisement

Table of Contents
loading

Table of Contents