Creating A Video Conference (Multiway ™ And Cucm) - Cisco TelePresence EX60 User Manual

Cisco TelePresence System EX60 & EX90
Creating a video conference
(Multiway and CUCM)
™
If your EX60 or EX90 is equipped with the optional
Multiway feature or connected to CUCM, you may call
more than one to initiate a video conference.
The maximum number of participants in a Multiway/
CUCM conference depends entirely on the video
infrastructure implemented in your organization. If in
doubt, consult your System Administrator.
If you want to initiate a video conference, you must
call each participant one by one.
Call settings. Those you call may have video systems
with different capabilities. One of them may, for
example, be on an ADSL system with limited bandwidth
(compared to the others). You may then set the Call
settings to a (normally lower) call rate (bandwidth)
suiting his or her system before you call that person.
However, that call rate will affect that specific part of
the video conference only. Other participants will not
suffer from a lower call rate because of this.
D1501606 User guide EX60 & EX90, English
All contents are copyright © 2010–2013 Cisco Systems, Inc. All rights reserved. Version TC6.2, 07.2013
While already in a
call, tap Hold.
Search or type the name
or address of the next
participant in the usual way.
Repeat the procedure from , if
needed.
A maximum four video systems
(yourself included) and one audio call
may participate.
If you initiated the conference you will be able to terminate the entire conference as well.
The other participants, however, may only disconnect themselves from the conference.
16
+
Tap Place New Call...
Tap CALL to place the second
call, initiating a conference.
Tap END to terminate the
conference.
www.cisco.com
User guide