Cisco MX300G2 Manual page 9

Create the in-room control panel
Table of contents
Introduction
Start the design of the in-room control panel
If an in-room control panel was not automatically loaded when you launced the
Create a user interface Create a user interface
editor, choose one of these alternatives:
• New
API for in-room control
• Import > From file
to a local file on an earlier occasion, into the editor.
• Import > From codec
Widgets
system into the editor. Not available in the offline editor.
All alternatives erase any unsaved data in the editor, but the existing in-room
Command reference
control panel on the video system is neither overwritten nor deleted until a new
panel is exported to the video system.
Troubleshooting
Tips and tricks
Examples
D15358.01 APRIL 2016
Collaboration Endpoint software
version 8.1
© 2016 Cisco Systems, Inc.
All rights reserved.
creates a blank in-room control panel in the editor.
loads an in-room control panel, which has been exported
loads the current in-room control panel from the video
Start or continue the design of an in-room control panel
9