Cisco MX300G2 Manual page 39

Update the in-room control panel
Table of contents
When you export a new in-room control panel to the video system, the old
panel is overwritten and replaced by the new one.
Introduction
a. Launch the in-room control editor from the video system's web interface.
b. Create the in-room control panel you want, or import a previously saved
panel from file
Create a user interface
c. Click
API for in-room control
Remove the in-room control panel and icon
Widgets
If there is an in-room control panel on the video system then there is also an
in-room control icon in the Touch 10 status bar. Even if the panel is empty and
contains no widgets, both the icon and the panel will be visible.
Command reference
Perform the following steps to remove the in-room control panel and icon from
Touch 10:
Troubleshooting
a. Launch the in-room control editor from the video system's web interface.
b. Click Settings.
Tips and tricks Tips and tricks
c. Click the
Examples
D15358.01 APRIL 2016
Collaboration Endpoint software
version 8.1
© 2016 Cisco Systems, Inc.
All rights reserved.
(Import > From file).
Export > To codec.
Delete icon in the Remove configuration section.
Choose an in-room control icon
The icon to tap to open the in-room control panel appears in the status bar on
Touch 10. This icon is also known as the entry icon.
You can choose between two icons: a light bulb (default), or a generic utility
icon. We recommend that you use the light bulb for environmental controls like
lights and blinds, and the generic utility icon for other things.
a. Launch the in-room control editor from the video system's web interface.
b. Click Settings.
c. Click the entry icon that suits your needs.
d. Click Export > To codec to apply the change.
39
In-room control icon