Table of Contents
Advertisement
SNMP Agent Configuration Menu
5.2.2
•
SNMP Read Community – SNMP community string used for SNMPv1/SNMPv2c read access.
This string can be up to 30 alphanumeric characters.
•
SNMP Write Community – SNMP community string used for SNMPv1/SNMPv2c write access.
This string can be up to 30 alphanumeric characters.
•
SNMP Trap Community – SNMP community string used for SNMPv1/SNMPv2c trap access.
This string can be up to 30 alphanumeric characters.
•
SNMP v3 Auth Password – Authentication password stored in flash. Will be used when Agent is
managing passwords locally or initially for all cases on reboot. This is the SNMPv3 password
used for Authentication. This string can be between 8 and 30 alphanumeric characters.
NOTE
Only MD5 authentication is supported for SNMPv3
•
SNMP v3 Priv Password – Privacy password stored in flash. Will be used when Agent is
managing passwords locally or initially for all cases on reboot. This is the SNMPv3 password
used for Privacy (DES encryption). This string can be between 8 and 30 alphanumeric
characters.
•
SNMP Mode – The mode of operation of the SNMP Agent. Choices are disabled,
,
v2_only
v3_only
any SNMP traffic. If the mode is
that version of SNMP traffic. If the mode is
specified version of SNMP traffic.
•
Trap Version – This specifies what version of SNMP will be used to encode the outgoing traps.
The different versions of SNMP will include different information in the traps. The choices are
,
v1_traps
v2_traps
a v3 header.
[v1_traps, v2_traps, v3_traps; v1_traps]
•
Auth Trap Enable – Indicates whether or not traps will be generated for login events.
enabled; disabled]
•
SNMP v3 Password Mode – Determines whether v3 passwords are managed locally or via an
SNMP Manager. The different behaviors of the Agent depending on the mode specified here are
described above for Auth and Priv Password.
•
SNMP Trap Manager #1 - #4 – Specifies an SNMP Manager on the network that traps will be
sent to.
[Any valid IP address; 0.0.0.0]
MDS 05-6906A01, Rev. R
Figure 14. SNMP Agent Configuration Menu
,
, and
. If the mode is disabled, then the Agent will not respond to
v1-v2
v1-v2-v3
v1_only
[v1_only, v2_only, v3_only, v1-v2, v1-v2-v3; v1-v2-v3]
, and
. When
v3_traps
v3_traps
TD220MAX Technical Manual
,
, or
, then the Agent will only respond to
v2_only
v3_only
, or
, then the Agent will respond to the
v1-v2
v1-v2-v3
are selected, v2-style traps will be sent but with
[manager, local; manager]
,
v1_only
.
[disabled,
19
Advertisement
Table of Contents
