Honeywell Dolphin 6110 User Manual page 24

Battery Pack
Caution: We recommend use of Honeywell Li-Ion battery packs. Use of any non-Honeywell battery may result
in damage not covered by the warranty.
There are two Li-ion battery packs available for the 6110:
Standard Capacity:
Extended Capacity:
Changing the Battery Pack
Before installing a battery pack, press the Power button to put the terminal in
3-15) so that operations are suspended before removing the main power source. The Dolphin 6110 is
shipped with the battery separate from the unit. You will need to loosen the hand strap, remove the
battery door, insert the battery, and replace the battery door. Refer to the instructions included in
the Battery section (page 2-1).
Note: The battery door must be installed prior to booting the unit.
Charging Options
When the battery is installed in the terminal, you can use any of the peripherals listed below to charge the
battery.
• Dolphin HomeBase/eBase Device
• Dolphin Comm/Charge Cable;
6110 (see page 6-2). You may charge the device using the USB connection if you do not have a wall
adapter. There are two options that allow either 100mA or 500mA of current over the USB connection.
Access the option by selecting Start > Settings > Control Panel > Power > USB Charging.
To fully charge the Li-Ion battery before installing it in the terminal, use the
• Dolphin QuadCharger Device
in the back of either the Dolphin HomeBase or Dolphin eBase.
Charging Time
The 3300mAh battery pack charges to full capacity in an average of 5 1/2 hours for a fully depleted
battery. It takes less time if the battery has some charge.
Li-ion 3.7V/2200mAh/8.1Wh
Li-ion 3.7V/3300mAh/12.2Wh
(see page 8-1)
Connecting the USB Charging/Communication Cable for the Dolphin
(see page 9-1) or insert the battery in the spare battery charging well
Suspend Mode (see page
Cover Locks
Battery
Install
3-13