Channelling the Cables from the Bottom of the Box
Channelling the Cables from the Bottom of the Box
Channelling the Cables from the Bottom of the Box
Channelling the Cables from the Bottom of the Box
As an alternative, you can channel the cables so that they exit from
the bottom of the box (see Figure 3). This alternative procedure
consists of the following steps:
1. Drill a hole in the breakaway tab and apply a cable clamp with a
clutch for the cable tube.
2. Remove the cable clamps from the rear side and apply the stopper.
Figure 3: Channelling the cables from the bottom of the box
Attaching the Terminal Support Plate
Anchor
PG9 cable
clamp
Multi-pole
cable
(15 poles)
Anchor
Page 9