Table of Contents
Advertisement
Closing the Terminal (Turnstile-mounted assembly)
Closing the Terminal (Turnstile-mounted assembly)
Closing the Terminal (Turnstile-mounted assembly)
Closing the Terminal (Turnstile-mounted assembly)
To close a anchor-mounted terminal, follow these steps:
1. Unscrew the special closure screw by turning it in an anti-
clockwise direction so that the terminal closure remains fully open
(in the direction of the wedge).
2. Insert the upper shell as indicated in Figure 12.
3. Fasten the special closure screw by turning it in a clockwise
direction and pushing down on the shell so that the fitting is
completely secure.
4. Tighten the screw.
Figure 12: Closing the terminal (anchor-mounted assembly)
Page 16
Assembling the Terminal Closure Guide
Advertisement
Table of Contents
