Table of Contents
Advertisement
Identification via the Service Pin
Identification via the Service Pin
Identification via the Service Pin
Identification via the Service Pin
To identify the node, you can call the service pin by means of a relay-
reed located inside the unit (see Figure 13). This procedure consists
of the following steps:
1. Position a small magnet as illustrated in Figure 13 to call the
service pin. This signal is linked to the yellow central service LED,
which flashes throughout the node configuration procedure.
2. The TemaServer, in response to the service pin, sends a wink
command that makes yellow LED flash three times. This allows you
to verify that the communication to and from the TemaServer is
working.
3. Check that the service LED remains off after you have completed
this operation.
Figure 13: Using a magnet to call the service pin
Identification via the Service Pin
ACTIVATION
Magnet
service pin
(reed)
Magnet
SERVICE
LED
service pin
(reed)
service
LED
Page 17
Advertisement
Table of Contents
