Figure 5-46 Modify Card - Honeywell IP-AK2 Installation And Configuration Manual

Setting
Card Holder Name
Card Type
Activation
Expiration
PIN
NO. of uses
Pin Not Required
Access Level
Trace
3. Click【OK】.
Modifying Card
1. Click the name of a card to be modified to select it, and click【Edit Card】below
the list to open the page below:

Figure 5-46 Modify Card

2. Change card properties.
3. Click【OK】to accept changes.
Deleting Card
1. Click the name of a card to select it.
2. Click【Delete Card】below the list.
Description
Identifies the card holder. A card holder's name includes first name
and last name. Each name supports up to 25 characters.
Specifies whether the card holder is an employee, VIP, or a
temporary employee (Temp). A card type is required.
Specifies the date that a temp card is activated. Note that this field is
active only when the Card Type is set to Temp.
Specifies the date that a temp card is de-activated. Note that this field
is active only when the Card Type is set to Temp.
Specifies the Personal Identification Number (PIN) for the card
holder. A PIN is optional; however, if the door reader is configured to
require PIN identification, then you must create a PIN for the card
holder here.
The PIN number has a maximum of six digits.
Specifies the number of times the card can be successfully treated as
valid on a panel.
If it's checked, the card will be granted access without input PIN code
even if PIN is required in reader mode.
Specifies the time zone, or time schedule, during which the card
holder can be granted access at specific doors. Up to 32 access
levels can be supported by one card.
Sends an alarm message to the alarm monitor whenever a card with
trace enabled is presented at a reader. This feature provides a trace
of the cardholder's path through the facility.
Honeywell
39