Setting Factory Defaults; Registering The Communicator; Registering Through The Alarmnet 360 Website - Honeywell LTE-X series Installation And Setup Manual

Setting Factory Defaults

To reset the programming options to factory-default values, press [ESC] at the "Exit Prog Mode?" prompt.
Set Default?
Y/N_
If you press [Y], all programmed values and password are reset to the original factory settings.
After pressing [Y], the Create Password prompt appears (see Programming step 4).

Registering the Communicator

Once you have programmed the communicator, it must be registered to enable the AlarmNet account. Registering the
communicator activates the account with AlarmNet and enables the security system's control panel to send reports. You
can register by using one of the following methods:
•
AlarmNet 360 website
•
Test Message / Registration switch
The top display LED will indicate the communicator's registration status as follows: (Refer to the Summary of
Connections topic.)
LED Indication
REG ON – Module is NOT registered with AlarmNet.
(green) OFF – Module is registered with AlarmNet.
You can monitor the registration process by viewing the display LEDs. The TX/RX (yellow) LED and the REG (green)
LED will blink slowly in unison while registration is in progress.
When the registration successfully completes, the communicator enters a normal operating mode; the REG (green) LED
goes out and the TX/RX (yellow) LED is lit to indicate that the power-on / reset message is waiting to be sent. This
message will appear at the receiving station as "E339 803". The description may read "Trouble – Exp. Mod. Reset". If
registration is not validated within 90 seconds, the communicator times out, and the REG (green) LED will be lit solid.

Registering through the AlarmNet 360 Website

To register the communicator via the website, go to: AlarmNet360.com
Log in and follow the on-screen prompts. If you are not signed up for this service, click on "Dealer Signup" from the login
screen to create an account. You will be instructed how to proceed upon completing the sign-up form. Only one sign-up
per dealer is required. Once an initial user is established, additional logins may be created by that user.
NOTE: Central Stations can sign up by contacting AlarmNet Customer Service at
1 (800) 323-4576 and selecting option 1, then Option 1 again for Cloud Services;.
(Monday–Friday 8:30 am to 9:00 pm, Saturday 9:00 am to 5:30 pm ET)
Please have the following information available:
•
• Primary City ID (two-digit number).
Primary Central Station ID (two-digit hexadecimal number).
•
Primary Subscriber ID (four-digit number).
•
MAC ID and MAC CRC number (located on the box and inside the communicator).
After the communicator is registered, you may log out of the AlarmNet 360 website.
LTE-X Series Installation and Setup Guide
Press [Y] to reset factory default values.
Press [N] to cancel this function.
•
•
7720P Programming Tool
Phone
– 11 –