Honeywell 8732001 Installation & Operation Manual page 8

INSTALLING INTERIOR ASSEMBLY (CONT.)
11. Installing Batteries
a. Insert 4 AA high quality Alkaline batteries into the Battery Compartment in the
direction noted +/- on the Compartment. The Lock will beep 2 times, the keypad
will illuminate blue, and the Honeywell button will flash green twice to signify that
it has received power (Figure 11a).
NOTE: Do not touch the Keypad until the blue light turns off.
Do not use rechargeable batteries or non-alkaline batteries.
b. Slide the Battery Cover down into the track on the Interior Assembly to cover
the batteries (Figure 11b).
Light Indicator
12. Testing Lock
With the Door Open
a. Test the Lock using the Interior Knob. The Latch should move smoothly.
b. Test the lock using the Keypad. To lock press and then press " 1234"
to unlock.
INSTALLATION OVERVIEW
Keypad
Override
Access Key
Exterior Assembly
Strike Plate
3/4" (19mm) screws
Keys
Interior Assembly
Interior Assembly
Optional
3/4" (19mm) screw
Mounting Plate
7/8" (22mm) screws
Latch
Exterior Tailpiece
Assembly
Rubber Gasket
Battery
Cover
Interior
Knob
Figure 11a-b
Battery Cover
5/16" (8mm) screws
1" (25mm) Screw
Page 6