Vacation Mode / Secure Lock-Out Period / Sound On And Off Restore Factory Settings / Low Battery Warning - Honeywell 8732001 Installation & Operation Manual

Vacation Mode
With Vacation Mode enabled, the system enters into low-power comsumption mode.
During this mode, all buttons and functions including the remote controll will be invalid
until they are re-enabled (see steps below).
ENABLE:
PC
Hear 1 beep and Light Indicator illuminates green then lock door
DISABLE:
To disable the Vacation Mode, you must press and hold for more than 3 seconds,
then input to unlock the door. Vacation Mode is now disabled.
PC
NOTE: If you only press the
do not input
Secure Lock-out Period
Warning sounds and LED flashes red after 4 incorrect code attempts: Keypad shuts
down for 30 seconds.
Sound On and Off
You can "mute" or turn the "sound on" on your lock by entering the following.
(Factory setting is sound on).
PC
Sound Off (1) - Light Indicator illuminates green.
Sound On (2) - Hear 1 beep and Light Indicator illuminates green.
Restore Factory Settings
To reset the lock to the original factory settings including the Programming Code
and all User Codes remove one battery for 10 seconds. Reinsert the battery and
wait for a long and short beep. Press 3 times within 3 seconds. The lock will beep
and the light indicator will turn green.
Low Battery Warning
Beeps and LED flashes red for 5 seconds. Replace with good quality alkaline batteries.
Note: Removing batteries does not erase active Programming or User Codes.
10 1
, the system will remain in Vacation Mode.
PC
6 1 or 2
1 = Sound Off
2 = Sound On
UC
for more than 3 seconds but
PC
Page 10