Installing Interior Assembly - Honeywell 8732001 Installation & Operation Manual

INSTALLING INTERIOR ASSEMBLY
9. ATTACH THE CONTROL WIRE TO THE INTERIOR ASSEMBLY
a. Use care to attach the Control Wire male plug to the Interior Assembly female
socket connector (Figure 9a).
b. Do not force the Control Wire male plug into the Interior Assembly female
socket connector (Figure 9b).
c. The Control Wire male plug has two alignment tabs on the smooth side of the
plug which is the top of the plug (Figure 9c).
d. The Control Wire male plug is inserted with the smooth side up into the Interior
Assembly female socket connector (Figure 9d).
10. ATTACH THE INTERIOR ASSEMBLY TO DOOR
a. Position the Interior Assembly over the tailpiece and push the Interior Assembly
against the door (Figure 10a).
b. Using two 5/16" (8mm) screws and one 1" (25mm) screw, attach
the Interior Assembly to the Mounting Plate. DO NOT OVER TIGHTEN SCREWS
(Figure 10b).
5/16" (8mm) screws
1" (25mm) screw
NOTE: Lock and unlock using Interior Knob to see if the
latch is opening and closing easily.
Interior Wire
Connector
Figure 10a-b
Plug
Figure 9a-d
Page 5