Temporarily Disable Auto Lock - Honeywell 8732001 Installation & Operation Manual

Deleting User Codes
DELETE ONE EXISTING OR PRESET USER CODE
The unit comes with a factory User ID = 01 for User Code = 1234.
IMPORTANT: To delete 1 User Code , the lock must have more than 1 User Code
in its database.
PC
Hear 1 beep and Light Indicator illuminates green.
DELETE ALL USER CODES
IMPORTANT: this will delete the user codes but not the programming code, enter
the following.
PC
Hear 1 beep and Light Indicator illuminates green.
Automatic Lock Function
SET OR CANCEL AUTO LOCK
You can set the lock to automatically close after each time the lock is opened. Time
value range = 20 - 900 seconds, enter the following:
Set Auto Lock:
Hear 1 beep and Light Indicator illuminates green.
To cancel Auto Lock set the time to 00, enter the following:
Cancel Time Value Auto Lock:
Hear 1 beep and Light Indicator illuminates green.
Temporarily Disable Auto-Lock
DISABLE:
While in Auto-Lock mode, unlock door using , within 10 seconds you must turn the
locking knob by hand to the locked position, wait more than 2 seconds then turn the
locking knob back to the unlock position. The Auto-Lock mode is now disabled.
RESTORE:
To restore the Auto-Lock funtion, you can turn the locking knob by hand to the locked
position, wait more than 2 seconds or press the
2 Existing
3 re-enter
5 Time Value
PC
PC
ID
UC
re-enter
ID
PC
5 00
PC
Lock button on the keypad.
UC
ID
Page 9
UC