Makita DUH501 Instruction Manual page 9

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
When replacing the shear blades,
always wear gloves so that your hands do not
directly contact the blades.
NOTICE:
When replacing the shear blades, do
not wipe off grease from the gear and crank.
Installing or removing the shear
blades
CAUTION:
Attach the blade cover before
removing or installing the shear blades.
You can install 500 mm, 600 mm, or 750 mm shear
blades to your tool.
1. Place the tool upside down, and then remove 6 screws.
► 1 . Screw
2. Remove the cover and the plate.
► 1 . Cover 2. Plate
NOTE: The plate may remain on the cover.
3. Remove the rod.
► 1 . Rod
NOTE: The rod may remain on the cover.
4.
Remove 2 screws, the felt pad, the washers, and
the sleeves, and then remove the shear blades.
1
► 1 . Felt pad 2. Screw 3. Washer 4. Sleeve 5. Shear
blades
1
5. Remove the blade cover.
6.
Attach the blade cover to the new shear blades.
7. Adjust the crank so that 2 holes are lined up on
the alignment line.
2
2
► 1 . Hole 2. Alignment line
9 ENGLISH
1
2
3
4
1
5
1