Cisco 8832 User Manual page 18

Draft comment: Design Team: Please review this procedure.
Disconnect the wired expansion microphones before you install wireless expansion microphones. You cannot
use both wired and wireless expansion microphones at the same time.
Position the table mount plate on the table surface location where you want to place the microphone.
Remove the adhesive for the double-stick tape on the bottom of the table mount plate. Place the table mount
plate to adhere to the table surface.
Attach the microphone to the table mount plate. Magnets are embedded in the microphone to snap the unit
into place.
You can move the microphone and attached table mount to a different location on the table surface as needed.
Use care when moving to protect the unit.
Wireless Expansion Microphone, on page 16
Unplug any wired microphones.
Press Settings.
Select Admin Settings > Wireless Microphones.
Select either Wireless Microphone 1 or Wireless Microphone 2.
If the selected channel is available, a Pair microphone 1? or Pair microphone 2? prompt
appears and you see the Pair softkey on the phone screen.
If a microphone is already linked to a particular channel, it cannot pair on a different channel and the phone
screen shows that the microphone is linked.