Sharp MD-X8 Operation Manual page 7

(Continued)
Left speaker Leave a space of at least 2"(5cm).
  



   


    

To an AC outlet
AC 120V, 60Hz
WWWWWWWWWWWWWWWWWWWWW
WWW E L C O M E
WWWWWWM DWWO R L
A M E R I C A NWK E Y B O A R
WWWWWWWWWWWWWWWWWWWWW
*01-16
Right speaker
More than 2"(5cm)
W T OW S H A R P WWW
DWWWWWWW
DWWWW
6
H H H H H Removing the speaker grilles
1
Remove the lower part of the speaker grille first.
2
Remove the upper part of the speaker grille.
Caution:
When the speaker grilles are removed, the speaker diaphragms are
exposed. Make sure nothing comes into contact with the speaker
diaphragms.
H H H H H Mounting the speaker grilles
Fit the four posts on the speaker grille into the mounting holes and
push them lightly with the palm of your hand to secure.
H H H H H Placing the system
I Be sure to keep space between the units for ventilation.
I Keep the back and sides of this unit at least 2"(5cm) away from the
wall.
I If any kind of magnet or an electromagnet is placed too close to the TV
set and the system, irregular color may be seen.
TV set location
I Depending on the particular location of a TV set, color variations may
be seen on the TV screen. If this happens, move the system and its
speakers away from the TV and turn off the TV set. After 15 - 30
minutes, turn on the TV again.
The TV's own demagnetizing function should eliminate the variations.
However, if the color still does not look right, move the system further
away from the TV set.
Note:
I A cooling fan is built into this product to avoid heat buildup.When the
power is turned on, the cooling fan will run.
When the volume is increased, the cooling fan will run at high speed.
H H H H H Connecting the AC power cord
I After connecting the speakers, plug the AC power cord into a conven-
ient AC outlet. The LCD will present a demonstration display.
I Unplug the AC power cord from the AC outlet if the unit is not to be
used for a prolonged period of time.
Note:
I If the lead wires of a speaker wire are short-circuited while connecting
a speaker with the power on, the protection circuit will activete
resulting in no sound. Disconnect the AC power cord from the AC
outlet, and connect it again.
H H H H H Demonstration display
I After the power cord is unplugged or a power failure occurs, when the
power is turned back on, the LCD will present a demonstration display.
If this happens, set the clock (see page 10) to cancel the demonstra-
tion display on the LCD.
SETTING THE CLOCK
6
98.6.23, 10:29 AM