Intermediate Process Tray Assembly; Stack Job Offset - Canon Finisher-T1 Service Manual

Chapter 2

2.3 Intermediate Process Tray Assembly

2.3.1 Stack Job Offset

Job offset operation offsets paper stack to the front or rear when ejecting to sort the paper
stack.
The forward/backward movement of the copy delivered to the processing tray is controlled
by the front aligning plate and rear aligning plate.
The aligned copies are stapled or ejected according to the signal from the host machine.
When the power is turned on, the finisher controller PCB drives the aligning plate front
motor (M103) and aligning plate rear motor (M104) to return the two aligning plates to
home position.
The name and function of motors and sensors used by the stack job offset function are
shown below.
Front aligning plate
home position sensor (PI106)
Aligning plate
(front)
(FRONT
Light-shielding plate
2-12
Rear aligning plate
home position sensor (PI107)
Light-shielding plate
Front aligning plate motor (M103)
F-2-15
Aligning plate (rear)
Rear aligning plate motor (M104)
0009-2513
Paper