Chapter 1
Getting Started
Loosen and remove the waterproof connectors.
Step 3
Insert an Ethernet cable through the cable gland, and the rubber seal.
Step 4
Remove part of cable sheath.
Step 5
You will need an RJ45 crimping tool to attach the Ethernet wires to a connector. When done, connect the
Step 6
cable to the camera's Ethernet RJ45 socket.
If applicable, connect DI/DO wires, 12V DC power, or audio wires to the terminal block.
Step 7
Cisco Video Surveillance 8020/8030 IP Camera Reference Guide
Hardware Installation
1-9