Compatibility - Honeywell IntelliPath Series Installation And Setup Manual

Environmental:

Compatibility

For a list of control panels that are compatible with various features of this communicator,
go to:
http://www.security.honeywell.com/hsc/resources/MyWebTech.
After logging on, select the applicable communication product, and then select "Compatibility
Chart" under Essential Docs.
For UL installations, compatible control panels are:
For UL installations, any UL Listed control panel may be used. Note, that any control panel
that does not communicate via Honeywell's ECP data bus is compatible using the commu-
nicator's Zone Trigger mode.
For UL installations, compatible receivers are:
• MX8000
• 7810PC
• 7810iR-ENT
• Ademco 685
UL
Operating temperature: –20º to +55ºC, for UL installations 0ºC to
+49ºC
Storage temperature: –40º to +70ºC
Humidity: 0 to 95% relative humidity, non-condensing
for UL installations 0% to 85%
Altitude: to 10,000 ft. operating, to 40,000 ft. storage
(UL – can be used for supplemental reporting in ECP mode when
connected to model 7810iR-ENT; must be used for opening/closing ring
back in Zone Trigger mode when connected to control panel's DACT.)
(UL – PC based software receiver can be use as a primary alarm
receiver. Refer to the Installation and User Guide for requirements.)
(UL – can be used as a primary alarm receiver.)
(UL – Ademco 685 has not been evaluated by UL.)
The Automation System must be UL1981 Listed.
The IGSMHS4G has been evaluated for connection to police station receivers.
Section 1: General Information
1-5