Honeywell IntelliPath Series Installation And Setup Manual page 37

PROMPTS
Enable Pwr Save
73
(N)_
IP Connection
74
(Present)
Review? Y/N
75
4204/
ZONE
OPTIONS
TRIG.
2-4204
[Y], [N]
4 4
4 4
• Present
• Auto
Detect
[Y] = review
4 4
[N] = exit
Section 3: Programming the Communicator
DESCRIPTION
To meet the 24 hour UL battery backup requirement,
choose "Y" to enable this feature. If this causes
connectivity problems with certain routers or switches,
then choose "N" and wire the communicator so it is
plugged into a UL Listed UPS.
UL: Must be set to Y.
Press the [space] key to toggle between the options.
Press [ENTER] to select the configuration.
If "Present" is chosen, it is assumed that an IP is
connected to the device. If it is not detected, a Primary
Comm Path Failure message will be delivered after the
programmed fault time expires.
If "Auto Detect" is chosen, the device will always try to
use IP to communicate but it will not generate a
Primary Comm Path Failure unless it previously
detected the presence of IP. As soon as the presence of
IP is detected, a Primary Comm Path Restore message
is generated and the value of IP Connectivity program-
ming parameter is changed from "Auto Detect" to
"Detected".
From this point on, the software expects connectivity.
The auto detect logic will resume only when the
parameter is changed back to "Auto Detect".
Reviewing Programming Mode Entries
To review the programming options (to ensure that the
correct entries have been made), press [Y]. The
programming prompts are displayed again. Use the
up/down arrow keys to scroll through the program fields
without changing any of the values. If a value requires
change, simply type in the correct value. When the last
field is displayed, the "REVIEW?" prompt again
appears.
To exit the programming mode, press [N] in
response to the "REVIEW?" prompt, and refer to Exiting
Programming Mode below.
3-19