Return The Extender To Its Factory Default Settings - NETGEAR EX7000 User Manual

Return the Extender to Its Factory Default Settings

Under some circumstances (for example, if you lose track of the changes that you made to
the extender settings), you might want to erase the configuration and reset the extender to
factory default settings.
To reset the extender to factory default settings, you can either use the Reset button on the
rear panel or log in to the extender and reset it.
For a list of factory default settings, see
To use the Reset button to return the extender to factory default settings:

CAUTION:
This process erases any settings that you configured in the extender.
1. Insert a straightened paper clip into the hole of the Reset button and hold it for about
seven seconds.
Reset button
2. Release the button.
CAUTION:
Do not try to go online, turn off the extender, shut down the computer, or
do anything else to the extender until it finishes restarting!
The extender resets and restarts. This process takes about one minute.
AC1900 Nighthawk WiF Mesh Extender
Factory Default Settings
Maintain and Monitor the Extender
43
on page 72.