Decode Settings; Imager Settings; Trigger Settings; Notification Settings - Honeywell Dolphin CT50 User Manual

Decode Settings

Use the Decode Settings to scan bar codes that are densely packed. When enabled,
the scanner will only decode a bar code is part of it is at the center of the aimer.
Although you can adjust the Window dimensions, Honeywell recommends leaving
the settings at 50 to define the "center" area for the bar code.
Setting
Center Decode

Imager Settings

You should not need to modify the Imager Settings. The Override Recommended
Values setting is disabled by default. The recommended Imager Settings are
designed to work in a wide range of environments and should only be modified if
you have an advanced understanding of imagers.

Trigger Settings

Use the Trigger Settings to configure how the scan buttons work.
Setting
Decode Timeout

Notification Settings

Use the Notification Settings to configure how your computer responds when you
scan a bar code.
Setting
Good Read
Notification
Bad Read
Notification
Vibrate Enabled
34
Description
Enables the ability for the scanner to scan only the bar code
at the center of the aimer.
Description
Scanning automatically turns off after this number of seconds if the
scan trigger is pressed and nothing has successfully decoded.
Description
Enables or disables a good read notification. The
notification consists of a green blink of the Good Read
LED, a short beep, and an optional short vibration.
Enables or disables notification of a failed scan. The
notification consists of a red blink of the Good Read LED,
an error beep, and an optional short vibration.
Enables or disables whether the computer vibrates when
there is a good or bad read.
Dolphin CT50 powered by Android 6.0 User Guide
Default
Disabled
Default
Enabled
Disabled
Disabled