GE AF-600 FP Operating Instructions Manual page 2

Safety
Safety
WARNING
HIGH VOLTAGE!
Frequency converters contain high voltage when
connected to AC mains input power. Installation, start up,
and maintenance should be performed by qualified
personnel only. Failure to perform installation, start up, and
maintenance by qualified personnel could result in death
or serious injury.
High Voltage
Frequency converts are connected to hazardous mains
voltages. Extreme care should be taken to protect against
shock. Only trained personnel familiar with electronic
equipment should install, start, or maintain this equipment.
WARNING
UNINTENDED START!
When the drive is connected to AC mains, the motor may
start at any time. The drive, motor, and any driven
equipment must be in operational readiness. Failure to be
in operational readiness when the drive is connected to AC
mains could result in death, serious injury, equipment, or
property damage.
Unintended Start
When the drive is connected to the AC mains, the motor
may be started by means of an external switch, a serial bus
command, an input reference signal, or a cleared fault
condition. Use appropriate cautions to guard against an
unintended start.
WARNING
DISCHARGE TIME!
Frequency converters contain DC link capacitors that can
remain charged even when AC mains is disconnected. To
avoid electrical hazards, remove AC mains from the drive
before doing any service or repair and wait the amount of
time specified in Table 1.1. Failure to wait the specified
time after power has been removed prior to doing service
or repair on the unit could result in death or serious injury.
AF-600 FP Operating Instructions
Voltage (V)
200 - 240
380 - 480
525 - 600
High voltage may be present even when the warning LEDs are
off!
Discharge Time
Symbols
The following symbols are used in this manual.
WARNING
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury. It may
also be used to alert against unsafe practices.
CAUTION
Indicates a situation that may result in equipment or
property-damage-only accidents.
NOTE
Indicates highlighted information that should be regarded
with attention to avoid mistakes or operate equipment at
less than optimal performance.
Approvals
Minimum Waiting Time (Minutes)
4 15
0.75 - 3.7 kW 5.5 - 45 kW
1 - 5 hp 7 1/2 - 60 hp
0.75 - 7.5 kW 11 - 90 kW
1 - 10 hp 15 - 125 hp
0.75 - 7.5 kW 11 - 90 kW
1 - 10 hp 15 - 125 hp