Makita RT0700C Instruction Manual page 9

Double insulation
Hide thumbs Also See for RT0700C:
Table of Contents

Advertisement

Available languages

Available languages

Offset base (optional accessory)
012085
(1)
Offset base (optional accessory) is convenient
for work in a tight area such as a corner.
3
1
011858
Before installing the tool on the offset base, remove the
collet nut and collet cone by loosening the collet nut.
1
2
011985
Install the pulley on the tool by pressing the shaft lock
and firmly tightening the pulley with a wrench.
011859
Place the collet cone and screw the collet nut on the
offset base as shown in the figure.
1. Pulley
2. Collet nut
3. Collet cone
2
1. Wrench
2. Pulley
3. Shaft lock
3
1. Collet nut
2
2. Collet cone
1
011860
Mount the tool on the offset base
011861
Put an end of the belt over the pulley using a screwdriver
and make sure that its entire belt width fits over the
pulley completely.
011862
Secure it with a locking lever on the offset base.
1
3
011992
To install the bit, fall the tool with the offset base on its side.
Insert the hex wrench into the hole in the offset base.
With the hex wrench held in that position, insert the bit
into the collet cone on the shaft of the offset base from
the opposite side and tighten the collet nut firmly with a
wrench.
To remove the bit at replacement, follow the installation
procedure in reverse.
9
1. Pulley
1
2. Belt
2
1. Locking lever
2. Offset base
1
2
1. Wrench
2. Hex wrench
3. Bit
2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents