Speed adjusting dial
1
011835
The tool speed can be changed by turning the speed
adjusting dial to a given number setting from 1 to 6.
Higher speed is obtained when the dial is turned in the
direction of number 6. And lower speed is obtained when it
is turned in the direction of number 1.
This allows the ideal speed to be selected for optimum
material processing, i.e. the speed can be correctly
adjusted to suit the material and bit diameter.
Refer to the table for the relationship between the number
settings on the dial and the approximate tool speed.
Number
1
2
3
4
5
6
011932
CAUTION:
If the tool is operated continuously at low speeds
•
for a long time, the motor will get overloaded,
resulting in tool malfunction.
The speed adjusting dial can be turned only as far
•
as 6 and back to 1. Do not force it past 6 or 1, or
the speed adjusting function may no longer work.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
1. Speed adjusting
dial
min
-1
10,000
12,000
17,000
22,000
27,000
30,000
5
Installing or removing trimmer bit
1
3
011837
3
1
2
011987
CAUTION:
Do not tighten the collet nut without inserting a bit,
•
or the collet cone will break.
Use only the wrenches provided with the tool.
•
Insert the bit all the way into the collet cone and tighten
the collet nut securely with the two wrenches or by
pressing the shaft lock and using the provided wrench.
To remove the bit, follow the installation procedure in
reverse.
OPERATION
For the trimmer base
1
1. Dust nozzle
2. Thumb screw
3. Trimmer base
011989
1. Tighten
2. Loosen
3. Hold
2
1. Tighten
2. Loosen
3. Shaft lock
3
2