About Line Cards
Table 5-4
Attention
Port
1. The Attention LED can be lit only by using the hw-module attention-led location CLI command, which is useful for
Physical Characteristics
•
•
•
•
2-Port 100GE OTN Line Card
The 2-port 100GE OTN LC (NCS4K-2H-O-K) supports any combination of 100GE and OTU4 interfaces
using Cisco CPAK pluggable optics. Two CPAK receptacles are hosted on the faceplate.
Insert CPAK modules in the 2-port 100GE OTN LC handle side down.
Note
The card supports up to two-level ODU4, ODU3, ODU2, ODU1, ODU0, and ODUFlex nested switching
functions by interconnecting with the centralized agnostic switch fabric; 100-Gigabit Ethernet signals
are mapped using generic mapping procedure (GMP) over ODU4 according to ITU-T G.709 v3 (Section
17.7.5).
Figure 5-8
Cisco Network Convergence System 4000 Series Hardware Installation Guide
5-22
20-Port 10GE OTN LC Descriptions
1
Blue
The card needs attention.
Off
The card does not need attention.
Green
The link is up (including internal loopback).
Yellow
The link is down or a hardware failure has occurred.
Off
The slice is unprovisioned by software, the optics
module is missing, or the slice has been powered
down.
identifying and verifying which card needs attention.
Height—11.05 in. (280.6 mm)
Width—1.55 in. (39.4 mm)
Depth—14.25 in. (362 mm)
Weight—5.5 lb (2.5 kg)
shows the details of the front panel of the 2-port 100GE OTN LC and LEDs.
Chapter 5
Installing Route Processor Cards, Fabric Cards, and Line Cards