Abort A Z-Wave Action; Defaulting The Z-Wave Network; Using Vam As A Secondary Controller - Honeywell VISTA User Manual

Abort a Z-Wave Action

If you inadvertently make a wrong selection, (add, delete, or remove failed
device) click the Abort button to stop the process.

Defaulting the Z-Wave Network

To default and remove all Z-Wave devices, do the following:
1. Go to the Z-Wave Management screen (Automation > Z-Wave Setup)
2. Click Z-Wave Default to delete all devices from the controller.
NOTE: This defaults the Z-Wave network on the VAM and creates a new
network ID and removes Z-Wave devices from VAM only. This does not
exclude devices from the network. Each device will need to be individually
excluded before it can be re-included into the newly created network (or if
the device is to be used on a different locations network).
3. Select Yes. The following message is displayed:
This Z-WAVE controller is about to be factory defaulted and will
lose all devices in the enrolled list.
All Z-WAVE devices must be re-enrolled after this reset. Each
device will have to be excluded before it can be re-enrolled'

Using VAM as a Secondary Controller

VAM can be used as a secondary controller when connected to another Z-
Wave network.
NOTE: If VAM is configured as secondary controller, it cannot be used with
Total Connect Remote Services.
1. Remove any Z-Wave devices previously included in VAM.
Click Automation > Z-Wave Setup to display the Z–Wave Management
screen, then click Z-Wave Default and select Yes.
2. Press the Z-Wave Primary Controller button (located on the bottom
right of the Z-Wave Management screen) to switch VAM to secondary
controller. The Z-Wave Primary button changes to Z-Wave Secondary
accordingly.
3. Start the inclusion process at the other network's primary controller (see
controller's manual), then click the Add Device button in VAM's Z-Wave
Management screen to add (include) VAM to the controller. To remove
(exclude) VAM from the primary controller, start the exclusion process at
the other network's primary controller, then click the Remove Device
button in VAM.
NOTE: This action will automatically change the VAM back to a Primary
Controller.-Wave Advanced Setup (for Installer use only)
Yes or No
– 16 –