Controller Setup; Zone Setup - Russound CAM6.6T-S1 Instruction Manual

Zone Setup allows the installer to adjust properties of the UNO Keypad controlled CAM6.6 zone. This
series of menus allows the system's zones to be configured for these properties:
ZON VOL TRIM (ZonVT)
MASTER ENABL (MstEn)
1. ZON VOL TRIM
(ZonVT)
2. SYSON ENABLE
(SysOn)
3. PARTY ENABLE
(PtyEn)
4. MASTER ENABLE
(MstEn)
5. MUTE ENABLE
(MutEn)
CTRLR SETUP (CtlId)
Controller Setup is the basic configuration of the controller. This setup menu selects the options for
Controller ID and Factory Initialization. See Controller Setup - Flow Chart on page 71
1. CONTROLLER ID
(CtlId)
2. FACTORY INIT
(FInit)
SYSON ENABLE (SysOn)
MUTE ENABLE (MutEn)
This feature allows the installer to adjust the output volume to
each zone. -16dB (lowest) to 0dB (max)(-3DB default).
This feature is either disabled or enabled. If disabled (default), an
All On command activated from another zone will not turn on the
disabled zone. If enabled, an All On command activated from
another zone will turn on the enabled zone.
This feature is either disabled or enabled. If disabled, Party Mode
activation from another zone will not affect the disabled zone. If
enabled (default), the zone will participate with Party Mode.
This feature is either disabled or enabled. If disabled, the zone
cannot host a master keypad during Party Mode. If enabled
(default), the zone has the option of hosting the Master keypad.
This feature is either disabled or enabled. It allows the option of
enabling or disabling muting in a zone. If disabled, the zone will
not mute. If enabled (default), the zone will be muted when a
mute signal is received.
This defines the Controller ID for this system. The default is 1 but
when multiple controllers are used, each additional controller ID
must be sequential and unique and be set before being connect-
ed to the system. Note that the system must be restarted before
the controller will assume the new ID.
WARNING: This procedure returns the controller to its
original settings - use with discretion.
Factory Initialization allows the installer to erase all programmed
settings and returns the settings to the factory default settings.
INSTALLER
INSTALLATION MENU
PARTY ENABLE (PtyEn)
57