Transmitter Control Screen - RIDGID SeekTech SR-20 Operator's Manual

Powering the Transmitter
When the two units are connected with Bluetooth, pow‑
ering the receiver on or off automatically powers the
transmitter on or off�
The receiver alerts you to changes in the transmitter's
power status�
Setting the Frequency
Changing the receiver's frequency automatically updates
the transmitter's frequency to match� If the frequency is
changed on the transmitter, the receiver automatically
updates to match as well�
38 – English
Switching to internal
batteries�
Powered off due to
Power Key press�
Powered off due to
low battery�

Transmitter Control Screen

The following section applies to the SR-24 only.
When the devices are connected, you can see the trans‑
mitter's screen from the receiver� The transmitter control
screen allows you to control the transmitter's frequen‑
cy mode, choose between direct connect or inductive
mode, and adjust output power remotely� You can also
remotely power the transmitter on or off and know if the
transmitter has powered off unexpectedly�
Any changes made on the transmitter to frequency, di‑
rect connect or inductive mode, and output power can be
seen on the receiver�
To open the transmitter control screen on the receiver,
press the Menu Key , then press the Right Arrow Key
to toggle in and out of the transmitter's control screen�
If more than one Bluetooth enabled SeekTech trans‑
mitter is present, press the Left Arrow Key
through available transmitters� Press the serial number
listed below the transmitter icon to identify the specific
transmitter you want to control�
to cycle