Unpacking And Inspecting Equipment; Equipment Installation; General - Honeywell BENDIX/KING KY 96A Installation Manual

B
2.1

GENERAL

This section contains suggestions and factors to consider before installing the KY 96A,
KY 97A. Close adherence to these suggestions will assure more satisfactory perfor-
mance from the equipment.
The conditions and test required for the TSO and MOPS approval of this article are
minimum performance standards. It is the responsibility of those installing this article
either on or with a specified type or class of aircraft to determine that the aircraft instal-
lation conditions are within the TSO and MOPS standards. These articles must have
separate approval for installation in an aircraft. Any features in this equipment outside
the requirements of this applicable TSO and MOPS must be evaluated and approved
as part of the installation approval. The article may be installed only if performed under
14 CFR part 43 or the applicable airworthiness requirements.
2.2

UNPACKING AND INSPECTING EQUIPMENT

Unpack the equipment carefully and inspect each item for evidence of damage in-
curred during shipment. If a damage claim must be filed, save the shipping container
and all packing materials to substantiate your claim. The claim should be filed with the
transportation company as soon as possible. The shipping container and packing
should be saved in any case in the event that storage or reshipment of the equipment
is necessary.
2.3

EQUIPMENT INSTALLATION

The KY 96A, KY 97A installation will conform to standards designated by the custom-
er, installing agency, and existing conditions as to the unit location and type of instal-
lation. However, the following suggestions should be considered before installing the
KY 96A, KY 97A. The installing agency will supply and fabricate all external cables.
The connectors required are supplied by Bendix/ King. Connector pin function dia-
grams are included in this manual as
grams are included in this manual as
ble below for compatible installations.
Rev 4, Apr 2003
SECTION II
INSTALLATION
Figure 2-2, and
Figure 2-8 through
IM 006-00674-0004.dwd
KY 96A, KY 97A
Figure 2-3. Interconnect dia-
Figure 2-13. Refer to the ta-
Page 2-1