Table of Contents
Advertisement
B
before the five second delay is completed will return the radio to the Frequency mode
and the status of the Frequency mode prior to entering Channel mode remains the
same.
When in Channel mode, pressing the Transfer button will return the radio to Frequency
mode. The channel frequency will become the new USE frequency and the last USE
frequency will become the new STBY frequency. If the radio was in Direct Tune mode
(see
paragraph 3.3.E
button or allowing the radio to time out will bring it back to Standby Entry.
3.3.C.
Program Mode
The Program mode is entered by pressing and holding the CHAN button for longer
than two seconds. The last active frequency remains tuned and displayed in the USE
window. The last used channel is displayed when Program mode is entered. The
channel number flashes and turning either tuning knob changes the channel number.
Pressing the Transfer button will cause the frequency associated with that channel to
flash. The tuning knobs then work as in the Frequency mode, except that between the
rollover points (118.XX and 135.XX or 136.XX) dashes are displayed. These dashes
are used to de-program channels, and to display a channel that is unprogrammed.
When the channel frequency is flashing, pressing the Transfer button will cause the
frequency to stop flashing and the channel number to start flashing at which time a
new channel may be selected for programming.
3.3.D.
Program Secure Mode
Program Secure mode is used to secure or lock the frequency that is assigned to a
channel so that the frequency assigned to that channel cannot be changed. All chan-
nels or individual channels can be Program Secured. The following list of operations
is given to Program Secure or Un-Program Secure a channel:
To Program Secure a Channel
* Hold the CHAN button in for more than 2 seconds (Program mode).
* Momentarily press the Transfer button (flashing frequency).
* Change channel frequency to desired Program Secured frequency.
* Ground the Program Secure pin (TP 701).
* Momentarily press the Transfer button (Flashing channel number).
* Unground the Program Secure pin.
To Un-Program Secure a Channel
* Hold the CHAN button in for more than 2 seconds (Program mode).
* Ground the Program Secure pin (TP 701).
* Momentarily press the Transfer button (flashing frequency).
* Unground the Program Secure pin.
* Momentarily press the Transfer button (Flashing channel number).
3.3.E.
Direct Tune Mode
Rev 4, Apr 2003
below) prior to entering Channel mode, pressing the Transfer
IM 006-00674-0004.dwd
KY 96A, KY 97A
Page 3-2
Hide quick links:
Advertisement
Table of Contents
