Remote Frequency Transfer (J96A Pin 11 Or J97A Pin 12); Remote Channel Increment (J96A, J97A Pin L); Dim Select (J96A, J97A Pin A) - Honeywell BENDIX/KING KY 96A Installation Manual

B
The Direct Tune mode is entered from the Standby Frequency Entry mode or Channel
mode by pushing the Transfer button for longer than 2 seconds. The tuning knobs op-
erate as in Standby Frequency Entry, but will change the USE frequency, rather than
the STBY frequency. The radio will be tuned to the Active frequency.
Momentarily pushing the Transfer button returns the radio to Standby Frequency En-
try. The Standby frequency prior to Active Entry mode remains unchanged.
3.4

REMOTE FREQUENCY TRANSFER (J96A pin 11 or J97A pin 12)

The Remote Frequency Transfer button operates identically to the front panel Transfer
button with the exception that holding the Remote Transfer button for two seconds
does not place the radio in the Active Entry mode.
3.5

REMOTE CHANNEL INCREMENT (J96A, J97A pin L)

Pressing the Remote Channel button will cause the system to enter the Channel mode
of operation and will increment the channel from the previous channel number used.
3.6

DIM SELECT (J96A, J97A pin A)

When Dim Select is in the open position, display backlight dimming will track a 14 V
lighting bus. When Dim Select is connected to ground the display backlight brightness
tracks or follows a 28 V lighting bus. When Dim Select is connected to the aircraft sup-
ply voltage the display backlighting will be at half brightness.
Rev 4, Apr 2003 IM 006-00674-0004.dwd
KY 96A, KY 97A
Page 3-3