Honeywell BENDIX/KING KY 96A Installation Manual page 9

B
SPECIFICATION
EMISSION:
OCCUPIED BANDWIDTH:
POWER OUTPUT:
KY 96A:
KY 97A:
MODULATION:
SIDETONE OUTPUT:
MICROPHONE:
HARMONIC CONTENT:
HIGH TEMPERATURE PROTECTION:
DUTY CYCLE:
FCC IDENTIFIER:
RECEIVER SENSITIVITY:
RECEIVER SELECTIVITY:
Class C + D
(version dependent, see
Class A + B
(version dependent, see
RECEIVER OUTPUT:
AGC CHARACTERISTIC:
SQUELCH:
Rev 4, Apr 2003
TABLE 1-1 Technical Characteristics
TRANSMITTER
RECEIVER
paragraph 1.4)
paragraph 1.4)
IM 006-00674-0004.dwd
CHARACTERISTIC
6K 00A3E
25 kHz
5 watts minimum
5 watts minimum
70% modulation capability with 98% limiting.
Less than 15% distortion at 70% modulation.
Adjustable up to 100 mW into 500 ohms headphones.
Standard carbon or dynamic mic containing transistor-
ized preamp. Must provide 100 mVrms into 100 ohm
load.
Greater than 60 dB down from carrier.
If the transmitter or modulator circuits become hot
enough to potentially hurt any components in the trans-
ceiver, a protection circuit will automatically turn down
the transmitter power consumption and output power
(1.25 watts minimum).
1 minute on, 4 minutes off.
ASY7BL KY96A,KY97A
2 uV (hard) or less for 6 dB S+N/N with 1 kHz tone
modulated 30%.
-6 dB at +/- 8 kHz minimum. 40 dB at +/- 17 kHz. 60
dB at +/- 22 kHz. DO-186.
-6 dB at +/- 15 kHz minimum. 60 dB at +/- 43 kHz.
DO-186.
100 mW minimum into 500 ohms or 8 W into 4 ohms
(KY 96A) or 4 W into 4 ohms (KY 97A).
From 5 uV to 20,000 uV audio output will not vary
more than 3 dB.
Automatic squelch (internally adjustable carrier-to-
noise setting) with manual disable.
KY 96A, KY 97A
Page 1-3