Xfp Connections - Cisco SCE8000 Configuration Manual

Chapter 2 Introduction to the Cisco SCE8000 10GBE Platform
Figure 2-5
The interface connector on the 1-Port 10-Gigabit Ethernet SPA is a fiber optic receiver that supports one
XFP.
The types of optics modules that have been qualified for use with the 1-Port 10-Gigabit Ethernet SPA on
the Cisco SCE8000 platform are as follows:
•
•
•
•

XFP Connections

The qualified XFPs include an optical transmitter and receiver pair integrated with Clock and Data
Recovery (CDR) integrated circuits. The XFPs provide high-speed serial links at 10.3125 Gbps on single
mode fibers.
The transmit side recovers and retimes the 10 Gbps serial data and passes it to a laser driver. The laser
driver biases and modulates a laser, enabling data transmission over fiber through an LC connector. The
receive side recovers and retimes the 10 Gbps optical data stream from a photo detector trans impedance
amplifier and passes it to an output driver.
See the label on the XFP for technology type and model.
XFP dimensions are:
•
•
•
The XFP operating temperature range is 0°C to 70°C.
Table 2-4
XFP
XFP-10GLR-OC192SR
XFP-10GER-OC192IR
XFP-10GZR-OC192LR
XFP-10G-MM-SR
OL-16478-05
10GBE Small Form-factor Pluggable (XFP0)
XFP-10GLR-OC192SR
XFP-10GER-OC192IR
XFP-10GZR-OC192LR
XFP-10G-MM-SR
Table 2-4 lists the XFP port cabling specifications.
Height 12.5 mm
Width 18.35 mm
Length 71.1mm
XFP Port Cabling Specifications
Wavelength
1310 nm
1550 nm
1550 nm
850 nm
Cisco SCE8000 10GBE Installation and Configuration Guide
Introduction to SIPs and SPAs
Fiber Type
SMF
SMF
SMF
MMF
2-7