Cisco ONS 15454 SDH Reference Manual page 20

1.13.2 Card Replacement
1.13.2 Card Replacement
To replace an ONS 15454 SDH card with another card of the same type, you do not need to make any
changes to the database; remove the old card and replace it with a new card. To replace a card with a card
of a different type, physically remove the card and replace it with the new card, then delete the original
card from CTC. For specifics, refer to the Cisco ONS 15454 SDH Procedure Guide.
Removing any active card from the ONS 15454 SDH can result in traffic interruption. Use caution when
Caution
replacing cards and verify that only inactive or standby cards are being replaced. If the active card needs
to be replaced, switch it to standby prior to removing the card from the node. For traffic switching
procedures, refer to the Cisco ONS 15454 SDH Procedure Guide.
An improper removal (IMPROPRMVL) alarm is raised whenever a card pull (reseat) is performed,
Note
unless the card is deleted in CTC first. The alarm clears after the card replacement is complete.
In a subnetwork connection protection (SNCP), pulling the active XC10G without a lockout causes
Note
SNCP circuits to switch.
Do not reach into a vacant slot or chassis while you install or remove a module or a fan. Exposed
Warning
circuitry could constitute an energy hazard.
1.14 Software and Hardware Compatibility
Table 1-6
XC-VXL-2.5G cards for Releases 3.3, 3.4, 4.0, 4.1, and 4.6.
Table 1-6 ONS 15454 SDH Software Release/Hardware Compatibility—XC-VXL-2.5G Configurations
Hardware
XC-VXL-2.5G
TCC2
AIC-I
E1N-14
E1-42
E3-12
DS3i-N-12
STM1E-12
E100T-G
E1000-2-G
Cisco ONS 15454 SDH Reference Manual, R4.6
1-20
shows ONS 15454 SDH software and hardware compatibility for systems configured with
3.30.0x (3.3) 3.40.0x (3.4)
Not Supported Not Supported
Not Supported Not Supported
Not Supported Fully Compatible
Fully Compatible Fully Compatible
Not Supported Not Supported
Fully Compatible Fully Compatible
Fully Compatible Fully Compatible
Not Supported Not Supported
Fully Compatible Fully Compatible
Fully Compatible Fully Compatible
Chapter 1 Shelf and FMEC Hardware
4.0.0x (4.0)
4.1.0x (4.1) 4.6.0x (4.6)
Fully Compatible Fully Compatible
Required Required
Fully Compatible Fully Compatible
Fully Compatible Fully Compatible
Fully Compatible Fully Compatible
Fully Compatible Fully Compatible
Fully Compatible Fully Compatible
Fully Compatible Fully Compatible
Fully Compatible Fully Compatible
Fully Compatible Fully Compatible
April 2008