Operation - Makita DGA700 Instruction Manual

Optional accessory
1. Sanding lock nut 2.
1. Mount the rubber pad onto the spindle.
2. Fit the disc on the rubber pad and screw the sand-
ing lock nut onto the spindle.
3.
the sanding lock nut clockwise with the lock nut wrench.
reverse.
NOTE:

OPERATION

WARNING:
force the tool.
could cause dangerous wheel breakage.
WARNING:
ALWAYS replace wheel if tool is
dropped while grinding.
WARNING:
NEVER bang or hit grinding disc
or wheel onto work.
WARNING:
wheel, especially when working corners, sharp
edges etc.
WARNING:
NEVER use tool with wood cutting
blades and other saw blades. Such blades when
CAUTION:
is in contact with the workpiece, it may cause an
CAUTION:
Always wear safety goggles or a
face shield during operation.
CAUTION:
After operation, always switch off
the tool and wait until the wheel has come to a
complete stop before putting the tool down.
CAUTION:
hand on housing and the other on the side grip (handle).
Grinding and sanding operation
1
2
3
3. Rubber pad
workpiece.
In general, keep the edge of the wheel or disc at an
angle of about 15° to the workpiece surface.
During the break-in period with a new wheel, do not
the workpiece. Once the edge of the wheel has been
forward and backward direction.
diamond wheel
-
Optional accessory
/ diamond wheel, be sure to use only the special
wheel guard designed for use with cut-off wheels.
-
grinding.
of kickback, wheel breakage and overheating of the
in the workpiece. Let the wheel reach full speed
started in the workpiece.
change the angle of the wheel. Placing side pres-
the wheel to crack and break, causing serious per-
ated perpendicular to the material being cut.
lock nut onto the spindle.
12 ENGLISH
WARNING:
WARNING:
NEVER use cut-off wheel for side
WARNING:
Overstressing the wheel
WARNING:
Do not start the cutting operation
WARNING:
WARNING:
A diamond wheel shall be oper-
15°