Operation - Makita GA7060 Instruction Manual

Optional accessory
Only for tools with M14 spindle thread.
Installing or removing abrasive disc
Optional accessory
1. Sanding lock nut 2. Abrasive disc 3. Rubber pad
1. Mount the rubber pad onto the spindle.
2. Fit the disc on the rubber pad and screw the sand-
ing lock nut onto the spindle.
3.
tighten the sanding lock nut clockwise with the lock nut
wrench.
To remove the disc, follow the installation procedure in
reverse.
NOTE:

OPERATION

WARNING:
It should never be necessary to
force the tool. The weight of the tool applies ade-
could cause dangerous wheel breakage.
WARNING:
ALWAYS replace wheel if tool is
dropped while grinding.
WARNING:
NEVER bang or hit grinding disc
or wheel onto work.
WARNING:
Avoid bouncing and snagging
the wheel, especially when working corners,
sharp edges etc. This can cause loss of control and
kickback.
WARNING:
NEVER use tool with wood cutting
blades and other saw blades. Such blades when
CAUTION:
is in contact with the workpiece, it may cause an
injury to operator.
CAUTION:
face shield during operation.
CAUTION:
the tool and wait until the wheel has come to a
complete stop before putting the tool down.
CAUTION:
one hand on housing and the other on the side
grip (handle).
1
Grinding and sanding operation
2
3
workpiece.
In general, keep the edge of the wheel or disc at an
angle of about 15° to the workpiece surface.
During the break-in period with a new wheel, do not
the workpiece. Once the edge of the wheel has been
-
forward and backward direction.
10 ENGLISH
Never switch on the tool when it
Always wear safety goggles or a
After operation, always switch off