Canon FINISHER-C1 Service Manual page 137

9. Points to Note When Mounting the
Lattice Guide (lower)
Keep the following in mind when mount-
ing the lattice guide (lower) to the finisher frame.
9.1 Shutter Link
Fit the lattice guide (lower) so that its shut-
ter link [1] will engage with the shutter bar [2]
of the wing guide. (Figure 3-2) The shutter will
not operate unless engagement is correct.
9.2 Rear Edge Drop Member
Be sure that the claw-like section [2] at the
front end of the lattice guide (lower) will not
ride over the rear end member [1] of the swing
guide; otherwise, jams can occur.
COPYRIGHT © 1998 CANON INC. FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 4 MECHANICAL CONSTRUCTION
Figure 4-114A
[1]
[2]
Figure 4-115A
Figure 4-116A
[1]
[1]
[2]
4-7