Canon FINISHER-C1 Service Manual page 136

CHAPTER 4 MECHANICAL CONSTRUCTION
7. Removing the Grate-shaped
Upper Guide
1) Remove the slide guide [1].
2) Remove the five screws [2] (M4).
3) Remove the screw [3] (M3), and remove
the grate-shaped upper guide [4].
8. Removing the Grate-Shaped
Lower Guide
1) Remove the tray assembly.
2) Remove the three screws [1] (M4).
3) Remove the three screws [2] (M3), and open
the grate-shaped lower guide to the front.
4) Free the harness [5] from the harness
stop[8].
5) Disconnect the two connectors [6], and re-
move the grate-shaped lower guide [7].
4-6 COPYRIGHT © 1998 CANON INC. FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
[2]
[3]
Figure 4-111A
[2]
Figure 4-112A
[7]
Figure 4-113A
[1]
[2]
[4]
[1]
[6]
[8]
[5]