Repositioning The Shield Clamp - GE VersaPoint IC220PBI002 User Manual

4
▪
Close the shield connector (#5 above).
▪
Fasten the screws for the shield connector using a screwdriver. (#6 above).

Repositioning the Shield Clamp

The shield clamp (2a, below) in the shield connector can be adjusted to
accommodate thin or thick cable. The shield connection is delivered with the
clamp positioned for the connection of thicker cables (#2 below). In that position,
the bend in the clamp faces away from the cable. For thinner cables the bend in
the clamp faces towards the cable (#6 below).
If you need to change the alignment of the shield clamp, proceed as shown below:
▪
Open the shield connector housing (#1).
▪
Remove the clamp (#3), turn the clamp according to the cross-section of the
cable (#4) and then reinsert the clamp. (#5)
4-12 VersaPoint™ I/O System Profibus-DP NIU User's Manual – August 2005 GFK-1911B