Error Codes For Pcp Communication; Other Error Messages - GE VersaPoint IC220PBI002 User Manual

8

Error Codes for PCP Communication

05 /01
hex hex
Meaning
Cause
Remedy
06 /02
hex hex
Meaning
Cause
Remedy
06 /03
hex hex
Meaning
Cause
Remedy
06 /05
hex
Meaning A service parameter has been specified with a
Cause
Remedy
06 /06
hex
Meaning
Cause
Remedy
06 /07
hex
Meaning
Cause
Remedy

Other Error Messages

08 /00
hex
Meaning
Cause
Remedy
Depending on the I/O module, other specific error codes may also be used. These
codes are listed in the relevant data sheet/user manual.
8-36 VersaPoint™ I/O System Profibus-DP NIU User's Manual – August 2005
(state conflict)
A start or stop command was sent twice.
This error only occurs on a start or stop service:
As the start or stop has already been executed, the
service cannot be executed again.
No action required.
(hardware fault)
Access to the object failed due to a hardware fault.
For example, no I/O voltage.
Remove the hardware fault.
(object access denied)
The object has limited access rights.
It may be a read-only object or password-protected.
Check the access rights in the object description.
(object attribute inconsistent)
hex
value that is not permitted.
For example, an incorrect length specification or
subindex that is not permitted.
Check the parameters in the object description and
send the service again with the corrected values.
(object access unsupported)
hex
The service used cannot be applied to this object.
For example, a program sequence can be started or
stopped, but not read.
Check the object description to find out which
services are supported for this object.
(object non-existent)
hex
The object does not exist.
The "Index" parameter probably contains an invalid
value.
Check the object index in the object description and
send the service again.
(application error)
hex
Device-specific error message; no communication
error.
-
Refer to device description.
GFK-1911B