Accessories; Maintenance - Makita JR3050T Instruction Manual

Recipro saw
Hide thumbs Also See for JR3050T:
Table of Contents

Advertisement

MAINTENANCE

1. Limit mark
1. Brash holder cap
2. Screwdriver

ACCESSORIES

CAUTION:
These accessories or attachments are recommended for use with your Makita tool specified in this manual. The
use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita service center.
Recipro saw blades
Press the shoe firmly against the workpiece. Do not allow the tool to bounce.
005790
Bring the blade into light contact with the workpiece. First, make a pilot groove
using a slower speed. Then use a faster speed to continue cutting.
CAUTION:
Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly. Replace when they wear
down to the limit mark. Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the same time. Use only
identical carbon brushes.
1
Use a screwdriver to remove the brush holder caps. Take out the worn carbon
005791
brushes, insert the new ones and secure the brush holder caps.
1
To maintain product SAFETY and RELIABILITY, repairs, any other mainte-
nance or adjustment should be performed by Makita Authorized Service Cent-
2
ers, always using Makita replacement parts.
Plastic carrying case
7

Advertisement

Table of Contents
loading

Table of Contents