Operation - Makita JR3050T Instruction Manual

1
2
1. Blade clamp lever
2. Released position
3. Fixed position
1
1. Blade
1
1. Blade clamp lever

OPERATION

6
To install the saw blade, always make sure that the blade clamp lever is in
005787
released position
the blade clamp lever is in fixed position, rotate the blade clamp lever in the
direction of the arrow so that it can be locked at the released positon
3
Insert the saw blade into the blade clamp as far as it will go. The blade clamp
005788
lever rotates and the saw blade is fixed. Make sure that the saw blade cannot
be extracted even though you try to pull it out.
NOTE:
• If you do not insert the saw blade deep enough, the saw blade may be
ejected unexpectedly during operation. This can be extremely
dangerous.
To remove the saw blade, rotate the blade clamp lever in the direction of the
006665
arrow fully. The saw blade is removed and the blade clamp lever is fixed at the
released position
NOTE:
• If you remove the saw blade without rotating the blade clamp lever fully,
the lever may not be locked in the released positon
rotate the blade clamp lever fully again, then make sure that the blade
clamp lever locked at the released position
CAUTION:
• Always press the shoe firmly against the workpiece during operation. If
the shoe is held away from the workpiece during operation, strong
vibration and/or twisting will be produced, causing the blade to snap
dangerously.
• Always wear gloves to protect your hands from hot flying chips when
cutting metal.
• Be sure to always wear suitable eye protection which conforms with
current national standards.
• Always use a suitable coolant (cutting oil) when cutting metal. Failure to
do so will cause premature blade wear.
on the insulation cover before inserting the saw blade. If
.
.
. In this case,
.