HIKVISION DS-3WF01C-2N User Manual page 61

User Manual of DS-3WF01C-2N
5. Multiple devices are installed at the same area, the packet loss is
serious. Change channel can only improve the situation for a while.
① Multiple devices are installed at the same area, and there is no plan for the
frequency settings which will cause the same frequency interference. It is recommended
to separate the frequency of the devices. If the channel width is 20M, the frequency
difference between two devices should be more than 20MHz. For example, 2412MHz,
2432MHz, 2452MHz etc., or set to non-standard frequency: Click Network - > Wifi - >
select the corresponding wireless network SSID and click Edit > Advanced Settings - >
Country, select Compliance Test - > Click Save & Apply button, then click General Setup -
> modify the basic channel and save the application. Please refer to manual 7.2.1 Device
configuration section.
② Multiple devices IP conflict with each other; you need to modify the IP address
followed by click Network - > Interfaces -> General Setup ->IPv4 address. Please
reference manual 7.1.1 Common Configuration section.
6. Mobile phones and computers cannot connect to AP
TDMA function is not closed, please close the TDMA. Followed by click Network - > Wifi
- > select corresponding SSID and click Edit button > Advanced Settings - > check off
TDMA. For details, please reference manual 7.2.1 Device Configuration section.
7. Clients often dropped, the speed is slow.
④ There are too many clients connect to AP, please limit the number of access users.
⑤ AP signal is weak. Please improve AP transmission power or regulating the AP and
the user's position.
⑥
Check the saturation of users and network bandwidth.
61